1. Pass the 120-volt supply wires through
the center hole in the ceiling mounting
plate as shown in Figure 10.
2. Install the ceiling mounting plate on
the outlet box, by sliding the mounting
plate over the two screws provided with
the outlet box (Figure 10). When using
close-to-ceiling mounting, it is important
that the mounting plate be level. If
necessary, use leveling washers (not
included) between the mounting plate
and the outlet box. Note that the flat
side of the mounting plate is toward the
outlet box (Figure 10).
3. Securely tighten the two mounting
screws.
4. Carefully lift the assembly up to the
ceiling mounting plate and hang the fan
on the hook provided by utilizing one of
the holes at the outer rim of the ceiling
canopy (Figure 11). If using standard
UL Listed
Outlet Box
Outlet Box)
Figure 11
Figure 10
THE HOOK AS SHOWN IN FIGURE 11 IS ONLY
TO BALANCE FAN WHILE ATTACHING WIRING.
FAILURE TO HANG AS SHOWN IN FIGURE 11
MAY RESULT IN HOOK BREAKING, CAUSING
THE FAN TO FALL. HOOK MUST PASS FROM
INSIDE TO OUTSIDE OF CANOPY.
WHEN USING THE STANDARD BALL/
DOWNROD MOUNTING, THE TAB IN THE RING
AT THE BOTTOM OF THE MOUNTING PLATE
MUST REST IN THE GROOVE OF THE HANGER
BALL FAILURE TO PROPERLY SEAT TAB IN
THE GROOVE COULD CAUSE DAMAGE TO THE
WIRING.
TO REDUCE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT USE A SOLID STATE
SPEED CONTROL WITH THIS FAN. IT WILL
PERMANENTLY DAMAGE THE ELECTRONIC
CIRCUITRY.
6.
Making the Electrical
Connections
REMEMBER to disconnect the power. If
you feel you do not have enough electrical
wiring knowledge or experience, have your
fan installed by a licensed electrician.
Follow the steps below to connect the fan
to your household wiring. Use the wire
connecting nuts supplied with your fan.
Secure the connectors with electrical tape.
Make sure there are no loose strands or
connections.
WHEN MOUNTING THE FAN ON A SLOPED
CEILING, THE STANDARD BALL/DOWNROD
MOUNTING METHOD MUST BE USED. MAKE
SURE THE MOUNTING PLATE SLOTS ARE ON
THE LOWER SIDE BY SLIDING THE MOUNTING
PLATE FROM THE TOP DOWN.
Installing Fan to the
Electrical Box
mounting, seat the hanger ball in the
mounting plate socket. Make sure the
tab on the mounting plate socket is
properly seated in the groove in the
hanger ball (Figure 11).
Installing Fan to the
Electrical Box
