ENERGY KINETICS Smart Solar EWRA1, Installation Manual, Page: 13 / 56

EnerWorks Solar Water Heating Appliance
© 2011 EnerWorks Inc. - Page
13 -
Energy Kinetics Inc. / Installation
Manual

Energy Station is mounted to solar storage tank and thermosiphon loop connections are
completed.

Mains water connections are completed. Hot outlet and anti-scald valve (if applicable –
highly recommended) connections to home hot-water distribution network are completed.

Source and Storage wires are connected to Controller.

Tanks are filled with water and purged of air. Power or gas supply to pre-existing water
heater may be turned back on.

Collector(s) are installed are per Collectors Installation Manuals.

Line-set is connected to Energy Station. Collector loop is leak tested, charged with heat
transfer fluid and purged of air.

Fittings are insulated and collector flashing is installed.

Controller and Monitor are programmed and Appliance is commissioned.

Installer discusses Appliance operation and maintenance with homeowner and completes
and submits Product & Installation Registration Form included with Owner Manual and in
Appendices.
It may be possible to mount Energy Station to solar storage tank and to complete thermosiphon
loop connections prior to on-site installation. Energy Station may be installed to top-feed or to
bottom-feed storage tank.
Before proceeding with installation of EnerWorks Energy Station, make note of
serial numbers
(Fig.3.1)
on Product & Installation Registration Form included with
O wner Manual and in Appendices. Serial numbers are required for warranty
service.
Fig.3.1 – Energy Station Label.
Serial number