3.8
Resetting to the factory default settings
To reset the network camera to the original factory settings, go to the Setup
>
System
>
Maintenance web page (described in ”System
>
Maintenance” of Users Manual) or use the
Reset
button on the network camera, as described below:
•
Using the Reset button:
Follow the instructions below to reset the network camera to the factory default settings us-
ing the Reset button.
1. Switch off the network camera by disconnecting the power adapter.
2. Open the Micro-SD card cover.
3. Press and hold the Reset button (SW1) on the board with your finger while reconnect-
ing the power.
4. Keep the Reset button (SW1) pressed for about 2 seconds.
5. Release the Reset button (SW1).
6. The network camera resets to factory defaults and restarts after completing the factory
reset.
7. Tightly close the Micro-SD card cover to ensure waterproofness.
CAUTION:
When performing a Factory Reset, you will lose any settings that have been
saved.
(Default
IP
192.168.1.10
)
90
