40
TILT OVER ANGLE
This option is used to set the limit of the horizontal view angle so that the trim ring or ceiling does not obstruct the horizontal image when
zooming out (wide angle).
ON:
In some installations it is desirable for the dome camera to be able to see above the horizon. When this
option is chosen, the dome will tilt up over the horizon (about -0 degrees). When the lens is zoomed out,
you can see the ceiling line. But when the lens is zoomed in, the viewing angle is narrower, and the ceiling
line disappears.
Without Bubble:
The tilt range of the camera is limited to see the horizon so the picture shows part of the ceiling line.
With Bubble:
The tilt range of the camera is limited to see below the horizon (0 degrees).
Over Angle is not sufficient enough to avoid ceiling obstructions, please adjust Origin Offset of tilt angle as described below.
PANNING RANGE
When the dome camera is installed near a wall, panning range can be limited by user.
Enable:
ON / OFF
Swap:
ON / OFF
Auto Pan:
ON / OFF
Right Limit:
Set 0.0 ~ 359.9
Left Limit:
Set 0.0 ~ 359.9
