4.5.4 Cross
You can detect a moving object crossing a specified virtual line (cross line) in a watch area.
You can see current status of moving object by “Bounding Box”.
(„Bounding box” means you can see a virtual rectangle on moving object. In prior of this, you make sure that you set “On” in display and Bounding box in OSD
Setup)
Min.
Set the min size of object while object crossed.
Max.
Set the max size of object while object crossed.
Direction
Set the direction while object cross.
CW:
CW (Clock Wise)
CCW: CCW (Counter Clock Wise)
Both: CCW (Counter Clock Wise), CW (Clock Wise),
Tracking
Set the tracking use while object crossed.
Set Point
Set the cross line.
Clear
Remove the cross line.
Follow steps as below to set the Cross:
. Set the min size of the enter object and set the max size.
. Select the cross direction.
3. Select the tracking use while object crossed.
4. Select the “Set Point” for cross line.
Use the
Joystick
to set the location of the start point(yellow mark). Move the cursor (green mark) by pushing the
Joystick
, up, down, right or left.
Select the location of the end point.
Draw a cross line to end point from start point.
5. Select the Exit (with saving) and push the Joystick to the right. Press ESC to exit the program without saving.
NOTE: To minimize failure rate of “Cross”, you are recommended to draw horizontal Cross line than vertical line. Also cross line should be placed
on the position where object is passing fast.
NOTE: Malfunction might occur or the cross will be deactivated if the moving object reaches the edge of the Cross-line.
