39
4.17 Home Function Setup
FUNCTION
NONE / TOUR/ PATTERN / AUTO SCAN / PRESET
FUNCTION NUMBER
- - -
WAITING TIME
0~40 seconds
FUNCTION ENABLE
ON/ OFF
The Home function can be set so that the camera automatically goes to Preset, Tour, Pattern, Auto Scan after the keyboard controller has been idle for certain
time. For example, if the controller is idle for 0 seconds, the camera goes to preset .
On Power on mode, you can set the camera to go Preset, Tour, Pattern, Auto Scan in case of power off or black out.
Follow these steps to program the Home position:
. Select Mode by pushing the
Joystick
up or down to scroll through Home Function / Power On
. Select Function by pushing the
Joystick
up or down to scroll through the None, Tour, Pattern, Auto Scan or Preset functions.
3. Select Function Number and push the
Joystick
to the up or to the down. The recorded function number will list.
4. Select Waiting Time and push the
Joystick
to the up or to the down to select from 0 to 40 seconds. (Activated on Home Function only)
5. Select Function Use and turn to ON or OFF by pushing the
Joystick
to the up or to the down.
4.18 View Angle
FLIP
OFF, 90°, 00°, 0°, 0°, AUTO
OFF:
The dome camera moves until 90° vertically.
90°, 100°, 110°, 120°:
Allows the image to flip digitally when the camera moves over the setting angle vertically.
AUTO:
When the camera reaches the floor directly above the moving object, it will stop. At that time, release the
Joystick
handle instantly and pull it down again to run the auto-flip function. When you use the panning range,
we recommend using the flip mode to AUTO.
