Eneo FASTRAX III, Instruction Manual

Page: 34 / 48

28
• VIEW ANGLE SETUP
VIEW ANGLE SETUP
PANNING RANGE
FLIP : 90
°
TILT OVER ANGLE : ON
SAVE AND EXIT(ESC TO CANCEL)
FLIP
: OFF,90
°
,100
°
,110
°
,120
°
,AUTO(18X,26X,36X MODEL) : ON,OFF(22X MODEL)
OFF:
the dome camera moves until 90
°
vertically.
90
°
, 100
°
, 110
°
, 120
°
:
allows the image to flip digitally when the camera moves over the setting angle
vertically.
AUTO:
When the camera reaches the floor directly above the moving object, it will stop. At that time,
release the
Joystick
handle instantly and pull it down again to run the auto-flip function. When you
use the panning range, we recommend using the flip mode to AUTO.
TILT OVER ANGLE:
This option is used to set the limit of the horizontal view angle so that the trim ring or ceiling does not
obstruct the horizontal image when zooming out (wide angle).
ON:
In some installations it is desirable for the dome camera to be able to see above the horizon.
When this option is chosen, the dome will tilt up over the horizon (About -10 degrees). When the lens
is zoomed out, you can see the ceiling line. But when the lens is zoomed in, the viewing angle is
narrower, and the ceiling line disappears.
Without Bubble:
The tilt range of the camera is limited to see the horizon so the picture shows part
of the ceiling line.
With Bubble:
The tilt range of the camera is limited to see below the horizon
(10 degrees).
Over Angle is not sufficient enough to avoid ceiling obstructions, please adjust Origin Offset of tilt
angle as described below.
PANNING RANGE
When the dome camera is installed near a wall, panning range can be limited by user.
PANNING RANGE SETUP
(CTRL KEY)
RIGHT LIMIT : 000.0
LEFT LIMIT : 000.0
ENABLE : OFF
SWAP : OFF
AUTO PAN : OFF
SAVE AND EXIT(ESC TO CANCEL)
1. Place the dome camera under 90 degree vertically.
2. Set the right limit by pushing the
Joystick
to the right.
3. Set the left limit by pushing the
Joystick
to the left.
4. Set ENABLE to ON to use
To exchange the right and the left limit, set SWAP to ON.
To apply limits on the auto pan (endless panning), set AUTO PAN to ON.
NOTE: When you use the panning range, we recommend using the flip mode to AUTO. When the flip mode is
90
°
, 100
°
, 110
°
or 120
°
and you moves over 90
°
vertically, the panning range operates in opposite side.