Eneo FASTRAX III, Instruction Manual

Page: 19 / 48

13
3.4 Auto Scan (Shortcut:
SCAN
)
The Auto scan supports up to 17 programmed angles at user-programmable speeds. Follow these steps
to program Auto Scan:
AUTO SCAN SETUP
NUMBER : 01
TITLE : A01
MODE : NORMAL
SPEED : 5 STEP
START ANGLE : ----- ----- ---
END ANGLE : ----- ----- ---
SCAN DIR : CCW
SWAP : OFF
DWELL : 03 SEC
SAVE AND EXIT(ESC TO CANCEL)
NUMBER
:01 -08, 10-17,
09
:AUTO PAN mode
TITLE
:up to 12 characters.
MODE
:NORMAL, VECTOR, RANDOM (AUTO PAN mode :NORMAL, RANDOM only)
NORMAL: Move from start point to end point in panning only.
VECTOR:
Move from start point to end point including tilt and zoom simultaneously and
linearly. In some model, the zoom is fixed at wider angle and the zoom magnification
information is not displayed.
RANDOM: Move randomly between the start point and the end point.
SPEED
: 1 - 13 step, the lower number means the slower speed.
SCAN DIR
: Set the scan direction, CCW(Counter Clock Wise), CW(Clock Wise)
SWAP
: Swap the start point for the end point.
DWELL
: Set the dwell time at the both end, 01 – 99 seconds
1. Press the
SCAN
key to enter the auto scan menu directly. Or press the
MENU
key to display the main
menu on the monitor. Scroll to Auto Scan and push the
Joystick
to the right.
2. Select the” NUMBER” and set the desired number by pushing the
Joystick
left or right.
3. Select the “TITLE” and twist the
Joystick
to enter the title edit mode.
4. Twist the
Joystick
by changing the alphanumeric characters and move the next position. Or move
down to the character table and press
CTRL
or
IRIS OPEN
at the desired character then the cursor
position moves to the next position automatically. Push the
Joystick
left or right at the “ALL DELETE”
field to delete all characters. Push the
Joystick
left or right at the “EXIT” field to finish title edit menu.
TITLE EDIT MENU
A01
*
A B C D E F G H I J
K L M N O P Q R S T
U V W X Y Z 0 1 2 3
4 5 6 7 8 9 ( )
ALL DELETE
EXIT (ESC TO EXIT)