27
3.9 Alarm
ALARM SETUP
NO PRI FUN IN OUT HLD LATCH
01 1 001 NC ON 03 OFF
ALARM OUT SETUP
SAVE AND EXIT(ESC TO CANCEL)
NO
: alarm input number
PRI(Priority)
: The lower number has higher priority. (1 fixed)
FUN(Function)
: Stored function number to be called by alarm.
IN
: NO/NC - normally open/closed, OFF - ignore
OUT
: ON – TTL output on, OFF – No output.
HLD(Hold)
: Alarm will be held for programmed time (03 to 99 seconds)
LATCH
: ON – Alarm message will remain on the screen even though alarm input
is deactivated.
OFF – Alarm message will disappear on the screen after programmed
hold time when alarm input is deactivated.
ALARM OUT SETUP
OUT : ALARM
EXIT(ESC TO EXIT)
ALARM:
alarm output is operated during an alarm operation or by the short key of our
keyboard.
1-5 MIN(minute):
alarm output is operated during this setting time only by the function run of
the dome menu or the short key of our keyboard.
NOTE: This 1-5 MIN setting is not operated by an alarm.
3.10 Area Title
Enter a specific name on programmed angle between START and END. For the screen below,
when the camera points at an angle between 124.3
°
(PAN), 30.7
°
(TILT) to 359.5
°
(PAN), 45.4
°
(TILT), ABC will be displayed on the screen.
AREA TITLE SETUP
NUMBER : 01
TITLE : ABC
START ANGLE : 124.3 30.7
END ANGLE : 359.5 45.4
SWAP : OFF
SAVE AND EXIT(ESC TO CANCEL)
NUMBER
: 01-08
TITLE
: up to 12 characters.
SWAP
: Swap the start point for the end point.
