5
Follow steps below to store the Preset positions:
. Press the
PRST
key to enter the preset menu directly. Or press the
MENU
key to display the main menu on the monitor. Scroll to preset and push the
Joystick
to the right.
. Select the blank preset position to be stored by pushing the
Joystick
up, down, right, or left.
3. After selecting a blank position, press and hold
CTRL
, Use the
Joystick
to control the direction of the camera and lens.
4. After aiming the camera (view direction and lens control), release
CTRL
. The cursor will be on the Title then twist the
Joystick
handle or Press
Tele
or
Wide
Key to edit the preset title. Follow the procedure of the auto scan above to edit titles.
5. Select „CAMERA SET” and pushing the
Joystick
left or right. Then the preset camera setup displays.
Set FOCUS: AUTO, MANUAL, ONE PUSH
Select „AE SETUP” and pushing the
Joystick
left or right. Then the AE setup displays. Refer to the AE SETUP in the camera setup.
6. Set „DWELL TIME”(03-99second)
7. To select the next page of presets, scroll the page by pushing the
Joystick
to the Left on the first and last columns of the menu.
8. Repeat steps through 7 for each additional preset position.
9. Select SAVE AND EXIT by pushing the
Joystick
to the right. Press
ESC
to exit the Preset menu without saving.
NOTE: Press the HOME key at programmed preset position (*) to delete a programmed preset view.
The position, which is marked with *, already has the preset view assigned. To review the stored preset, press
PRST
key on the *. The camera will show the
stored preset scene.
PRESET AREA SETUP
(CTRL KEY)
NUMBER 00
PAN
TILT
000.0
000.0
EXIT (ESC TO EXIT)
Hold down the
CTRL
key while selecting the desired scene using the
Joystick
. Current position will be displayed. Release
CTRL
key to complete. Or Press
IRIS OPEN
then the „CTRL” displays. Move the desired position and the zoom position. Press
IRIS CLOSE
then the „CTRL” disappears. Select Exit and push
the
Joystick
to the right. Follow steps above to save the preset.
4.6 Shortcut of Preset Program
After selecting the desired scene, press No. (
1
to
240
), and press
CTRL
and
PRST
subsequently. The current view will be stored to the selected preset numb-
er if the preset number is empty. If selected preset number is not empty, „OVER WRITE” message will be displayed on the monitor and select the „OK” and
push the
Joystick
to the right to overwrite.
Example:
1
,
0
,
1
+
CTRL
+
PRST
will store current view as preset No.
101
. In this case, focus will be programmed as Auto, dwell time will be set to
3 seconds, and the current AE mode will be programmed.
PRESET CAMERA SETUP
FOCUS:
AUTO
AE SETUP
SAVE AND EXIT (ESC TO EXIT)