Endura FSTL1000, Operator'S Manual

Page: 9 / 18

11 www.uniquip.ca
Prior to setting up the FSTL1000
Tower Light, check that the
following items are enclosed:
If any of these items are missing, please contact 1-800-332-4012 and ask
for the Service Manager at Uniquip Canada Inc. at once.
DO NOT ATTEMPT ASSEMBLY OR OPERATION WITHOUT ANY OF
THESE LISTED PARTS!
Technical Support Hotline
Ontario,
Western Canada, and USA
T : 1-888-332-4012
F : 1-866-567-0956
Quebec
and Eastern Canada
T : 1-800-332-4012
F : 1-866-825-2221
email your technical questions and comments to:
service@uniquip.ca
visit our website:
www.uniquip.ca
Contents List
Item Quantity Check if enclosed
Ballast Assembly 1 ____Yes ____No
Cart Kit 1 ____Yes ____No
Lens Kit 1 ____Yes ____No
Reflecto 1 ____Yes ____No
Fixture 1 ____Yes ____No
1000 W Metal Halide Lamp 1 ____Yes ____No
Mast Kit 1 ____Yes ____No
Metal Ring 1 ____Yes ____No
Rubber Ring 1 ____Yes ____No
Package of Bolts and Washers 1 ____Yes ____No
Uniquip Endura FSTL1000
Tower Light Operator’s Manual 1 ____Yes ____No
10
www.uniquip.ca
1. Place Ballast Assembly on floor.
Tilt it such that the base of the assembly
faces the operator. Remove and put aside
washers from metal feet and brake.
Keep rubber supports on metal feet.
(Figure 1)
Figure 1.
2. Flip cart over ballast box
and line up ballast support
bars to metal feet. Tighten
ballast to cart with washers
from metal feet and brake.
(Figure 2)
Figure 2.
4. Place rubber ring on fixture.
Make sure that the ring is
correctly aligned to markers
on fixture. (Figure 4)
Figure 4.
5. Line up reflector to holes on rubber
ring and the markers on the fixture.
Place metal ring on top of the
reflector, again making sure that its
holes are lined up with the reflector
and fixture. Check that the security
chain hangs on the bottom of the
reflector. Bolt down assembly to
fixture with 4 bolts and washers.
(Figure 5)
Figure 5.
6. Place reflector on flat surface with
the fixture side up. Remove U-Bracket
kit, 2 large knobs, 1 smaller knob, 2
O-pins and 2 washers from package.
Line up U-Bracket to fixture such that
the holes on each side of the bracket
line up with holed on the sides of the
fixture. Attach bracket to fixture with
2 large knobs and washers.
(Figure 6)
Figure 6.
3. Turn cart and
ballast back to its
proper position.
Undo mast lock on
mast support.
Insert mast into
mast support and
tighten mast lock
to hold the mast in place.
(Figure 3)
Figure 3.
Setting up the FSTL1000