13
www.uniquip.ca
Setting up the FSTL1000 cont'd
7. Slide bracket and fixture onto
mast. Insert 3 pins into holes
to attach fixture to mast.
(Figure 7)
7. Slide bracket and fixture onto
mast. Insert 3 pins into holes
to attach fixture to mast.
(Figure 7)
Figure 7.
8. Unpack Lens Kit and attach
security chain on reflector to
lens. Let lens hang from
reflector and screw in
1000 W metal halide lamp
into fixture. Clip lens onto
fixture. (Figure 8)
9. Unwind security cable and
hook it onto lens clips.
Secure cable with spring.
(Figure 9)
Figure 9.
Figure 8.
10. Move Tower Light to desired area with level surface.
Set brake for extra stability.
Technical Support Hotline
Ontario,
Western Canada, and USA
T : 1-888-332-4012
F : 1-866-567-0956
Quebec
and Eastern Canada
T : 1-800-332-4012
F : 1-866-825-2221
email your technical questions and comments to:
visit our website:
www.uniquip.ca
14
www.uniquip.ca
Maintenance Procedures cont'd
Pre-Operation Procedures
Before using the Endura FSTL1000 Tower Light, please perform
the following procedures for the personal and property safety of the operator
and jobsite.
1. Before operating the light ensure that it is
structurally
and
mechani-
cally
safe by checking the following:
a. Inspect that all the sections of the Tower Light are properly
installed as per the guidelines in the section "Setting up the
FSTL1000".
i. Is the mast securely bolted into the mast support?
ii. Is the floor brake being used for further stability and to
hold the light in position?
iii. Are the wheels properly inflated?
iv. Is the lens secured clipped and chained to the reflector?
v. Is the cable worn, fouled or in any other conditions that
would prevent the light from safe operation?
2. Before using the light on proposed jobsite, perform the following
environmental
checks:
a. Check that available electrical outlets conform to local codes.
b. Run light only on GFCI protected circuits.
c. If the proposed jobsite is on an incline, counterbalance light with
weights to ensure stability.
d. Keep the light
at least 16' feet away
from any pools or spas.
e. Keep the lamp away from any flammable materials.
If any of the above check fail, please DO NOT operate the light.
CONTINUED USE OF FRAYED OR DAMAGED
CABLE CAN RESULT IN PROPERTY DAMAGE
AND/OR SEVERELY INJURING THE OPERATOR.
