15
www.uniquip.ca
Operation Procedures
1. Plug cord into any 15 amps or greater 120 volt 60 Hz power source.
2. Turn tower light on. As the light bulb is being energized, there will be a
slight humming noise issuing from the ballast.
3. Should there be any interruption in the power to the tower light, it will
require approximately 20 minutes to re-power the light bulb.
Always
switch light OFF before re-powering the unit.
4. To adjust the fixture bracket and light head, pull pin, raise bracket to the
vertical position and slide pin back in place.
5. When adjusting the light fixture, always make sure that the fixture is
COOL
before adjusting. Aim the fixture approximately 15° above desired level.
Tighten knobs lightly to hold fixture in place, then pull fixture down to
desired level. Completely tighten knobs to secure fixture.
6. To
raise
the telescopic mast, grasp upper-mast firmly and raise the post
until the safety lock is engaged. To further extend the mast, repeat with
second mast mast section.
7. To
lower
the telecopic mast, pull on safety lock while grasping raised mast
with one hand and raising it slightly.
SLOWLY
lower mast.
DO NOT
DROP MAST.
SAVE THESE INSTRUCTIONS!!
16
www.uniquip.ca
Notes
