EndRun Sonoma N12, User Manual

Page: 87 / 174

S o n o m a U s e r M a n u a l 70
C H A P T E R N I N E
71 S o n o m a U s e r M a n u a l
C O N T R O L A N D S T A T U S C O M M A N D S
ntpconfig Interactive script that guides you in configuring the NTP
Subsystem. Allows configuration of MD5 authentication and
broadcast/multicast mode. All parameters are retained in non-
volatile FLASH disk storage.
ntpstat Prints the values of several key parameters indicating the status
of the NTP daemon. These include the current offset between
the NTP-steered system clock and the GPS Subsystem clock,
and the current counts of received packets, sent packets and
dropped packets. In addition the current sent packet rate is
shown.
oscctrlstat Prints the system oscillator disciplining parameters.
passwd Used to change the password for the user that you are logged
in as.
ptpconfig0
ptpconfig1
(optional)
Interactive script that guides you in configuring parameters for
the optional PTP/IEEE-1588 protocol. See Chapter 4 - PTP/
IEEE-1588 for more information.
ptpstat0
ptpstat1
(optional)
Prints the status of the optional PTP/IEEE-1588 Subsystem.
See
Chapter 4 - PTP/IEEE-1588
for more information.
pwrfltmask
(optional)
Prints the current settings of the optional Dual Power Supply
Input Fault Alarm Masks. See Chapter 10 - Options, Masking
Dual Power Supply Fault Alarms
for more information.
rcvrserialnumber Prints the serial number of the GPS Receiver. This command is
not available in units shipped before June 2017.
rcvrstat Prints the status of the GPS Receiver. This command is not
available in units shipped before June 2017.
rcvrversion Prints the GPS Receiver firmware and FPGA version informa-
tion. This command is not available in units shipped before
June 2017.
resetlastgpswn For use with a GPS simulator. This command is not available in
units shipped before June 2017.
resetleaphistory For use with a GPS simulator. This command is not available in
units shipped before June 2017.
rcvrserialnumber Prints the serial number of the GPS Receiver. This command is
not available in units shipped before June 2017.
rcvrstat Prints the status of the GPS Receiver. This command is not
available in units shipped before June 2017.
rcvrversion Prints the GPS Receiver firmware and FPGA version informa-
tion.
This command is not available in units shipped before
June 2017.
resetlastgpswn For use with a GPS simulator. This command is not available in
units shipped before June 2017.
resetleaphistory For use with a GPS simulator. This command is not available in
units shipped before June 2017.