Endress ESE 20YW/RS, Original Operating Manual

Page: 24 / 52

Dimensions
24
Rental Line Status at: June 2016
4 HORN RESET button (reset horn). Use this button to deactivate
the horn output without acknowledging the alarm.
5 MODE LEFT button (mode left). Use this button to alter the operat-
ing mode. This button is only functional if the main window is dis-
played with the indicator of the currently selected operating mode.
NOTE:
This button is without function if the operating mode of the control-
ler is forced by one of the binary outputs Remote OFF, Remote
MAN, Remote ON, Remote TEST (remote controlled operating
modes SWITCH OFF, MANUAL, AUTOMATIC, TEST)
.
6 MODE RIGHT button (mode right). Use this button to alter the op-
erating mode. This button is only functional if the main window is
displayed with the indicator of the currently selected operating
mode.
NOTE:
This button is without function if the operating mode of the control-
ler is forced by one of the binary outputs Remote OFF, Remote
MAN, Remote ON, Remote TEST (remote controlled operating
modes SWITCH OFF, MANUAL, AUTOMATIC, TEST).
7 GCB button (generator circuit breaker). Only functional in the op-
erating mode MAN. Use this button to switch the GCB (generat or
circuit breaker) off or on manually. Please note that certain condi-
tions must apply otherwise the GCB (generator circuit breaker)
switching on will be blocked.
8 MCB button (mains network circuit breaker). Only functional in the
operating mode MAN. Press this button to switch the MCB (mains
network circuit breaker) off or on manually.
CAUTION!
This button separates the load from the mains power supply! Be
very clear about what you want to do!
Table 6 - 1 Control buttons of the E-MCS 6.0
Item Button Description
9 Gen-set failure (error on the generator). The red LED diode begins
to flash if there is a fault on the generator. After actuation of the
FAULT RESET reset button it begins to light up continuously (if an
alarm is still active) or goes out (if no further alarm is active).
10 Gen-set voltage OK (voltage of the generator OK). The green LED
diode lights up of there is a voltage present from the generator and
its parameters lie within the limit values.
11 GCB ON (generator circuit breaker switched on). The green LED
diode lights up if the GCB (generator circuit breaker) is switched
on. The diode is actuated with the output GCB CLOSE/OPEN
(AMF 8/9) or by the signal GCB Feedback (AMF 20/25).
12 MCB ON (mains network circuit breaker switched on). The GREEN