Status at:
February 2013
ESE 807 / 1107 / 1307 / 1407 DBG (ES) DIN
51
1.
Plug in the device and switch on.
The displayed symbol
(see Fig. 4-5-(8))
indicates the result:
Symbol
Significance
lights up red
The buzzer
sounds
Insulation fault (≤ 23 kΩ)
stays off
Connected unit is OK
Table 5.3: Insulation monitoring whilst running without switching off
If an insulation fault exists and the unit was previously
OK when tested without a device connected (see insula-
tion monitoring above), the insulation fault has been
caused by the device.
2.
The reset button
(see Fig. 5-2-(1))
must be pressed after
switching off and disconnecting the device so that the
unit can be operated again.
Insulation monitoring
whilst running:
Summary of Contents for ESE 1107 DBG DIN
