Endress+Hauser TopClean S CPC 30, Operating Instructions Manual

Page: 29 / 146

TopClean S CPC 30 5 Operation
Hauser 29
5.1.7 Factory setting
All the factory settings are active when the instrument is switched on for the first time.
The table below lists all the main settings. For all further factory settings, please refer to
the "Description of functions" chapter (from p. 34); the factory settings are printed in
bold .
5.2 Replaceable memory
The DAT module is a memory device (EEPROM) which is plugged into the connection
compartment of the transmitter. Using the DAT module you can
• save
the complete settings, the logbooks and the data logger of a transmitter and
• copy
the complete settings to other CPM 153 transmitters with identical hardware
functionality.
This considerably reduces the effort to install or service several measuring points.
Parameter One-circuit instrument
Select operating mode pH
Select measuring principle One-circuit circuit 1
Select electrode type Glass electrode 7.0
Select connection type Solution ground
Select temperature display Deg. C
Select temperature compensation ATC
Temperature measurement Off
Select temperature sensor Pt 100
Contact functions NAMUR
Select current output 1 pH/redox K1
Select current output 2 Temperature K1
Hold Active with PARAM and CAL
(inactive with DIAG)
Current
output 1:
0/4 mA value:
20 mA value: pH 2 / –1500 mV / 0.0% / 0.0 °C
pH 12 / +1500 mV / 100.0% /
100.0 °C
Current
output 2:
0/4 mA value:
20 mA value:
Temperature
0.0 °C
100.0 °C