Tankvision Gauge Link
Document information
Hauser
3
1
Document information
1.1
Target audience for this manual
This manual should support during the installation of the NXA20 units. It deals with the
mechenical, electrical and signal line installation. The first commisioning steps are described
as well.
Beside basic PC operating knowledge no special training is needed to perform the Tank
Gauging System operations. Nevertheless it is recommended receiving a training on the
system by Hauser.
1.2
Version history
1.3
Document function
1.3.1
Used symbols
Safety symbols
Electrical symbols
Document version
Valid for SW version
Changes to the previous version
BA01335G/00/EN/01.14
1.1.0
Initial version
Symbol
Meaning
A0011189-EN
DANGER!
This symbol alerts you to a dangerous situation. Failure to avoid this situation will
result in serious or fatal injury.
A0011190-EN
WARNING!
This symbol alerts you to a dangerous situation. Failure to avoid this situation can
result in serious or fatal injury.
A0011191-EN
CAUTION!
This symbol alerts you to a dangerous situation. Failure to avoid this situation can
result in minor or medium injury.
A0011192-EN
NOTICE!
This symbol contains information on procedures and other facts which do not result
in personal injury.
Symbol
Meaning
A0011197
Direct current
A terminal to which DC voltage is applied or through which direct current flows.
A0011198
Alternating current
A terminal to which alternating voltage is applied or through which alternating current flows.
A0011200
Ground connection
A grounded terminal which, as far as the operator is concerned, is grounded via a grounding
system.
A0011199
Protective ground connection
A terminal which must be connected to ground prior to establishing any other connections.
DANGER
WARNING
CAUTION
NOTICE
)
*
