Monorack wiring
Fig 2.8 shows the terminals in the base of the Monorack II housing, the pin assignments
correspond to those in Fig. 2.5. When connecting together several Monoracks, follow
the instructions supplied with the housing.
•
Set the jumper to the position "Racksyst I".
•
Insert the coding pins supplied at positions 1 and 23 in the female connector
in the base of the housing.
•
The pin designation printed in black are valid for Silometer FMB cards.
If you are installing the Silometer FMB in a Monorack I housing, please note that there is
no jumper switch. In addition, for the 24 V version, the dummy card in the power control
slot must be replaced by the 24 V card suppied.
Power
control slot
Jumper set for
Racksyst I card
BA064E14
Power
Outputs, use
black marked
see Fig. 2.5
Channel 1, d2, d4
Insert coding
pins at
positions
1 and 23
Hole for mounting
screw
Hole for mounting
screw
Channel 2, z2, z4
Fig. 2.8:
Layout of Monorack II terminal
blocks
Silometer FMC 672 Z/677 Z
Chapter 2: Installation
15
