Operation
Promag 50
58
Hauser
5
Operation
5.1
Display and operating elements
The local display enables you to read all important parameters directly at the measuring point and
configure the device.
The display area consists of two lines; this is where measured values are displayed, and/or status
variables (direction of flow, partially filled pipe, bar graph, etc.). You can change the assignment
of display lines to variables at will in order to customize the display to suit your needs and
preferences (
"Description of Device Functions" manual).
A0001141
Fig. 47:
Display and operating elements
1
Liquid crystal display
The two-line liquid-crystal display shows measured values, dialog texts, error messages and information messages.
The display as it appears when normal measuring is in progress is known as the HOME position (operating mode).
– Upper display line: Shows primary measured values, e.g. volume flow in [ml/min] or in [%].
– Lower display line: Shows supplementary measured variables and status variables, e.g. totalizer reading in [m3],
bar graph, measuring point designation
2
Plus/minus keys
– Enter numerical values, select parameters
– Select different function groups within the function matrix
Press the +/- keys simultaneously to trigger the following functions:
– Exit the function matrix step by step
HOME position
– Press and hold down +/- keys for longer than 3 seconds
Return directly to HOME position
– Cancel data entry
3
Enter key
– HOME position
Entry into the function matrix
– Save the numerical values you input or settings you change
Esc
E
+
-
1
3
2
+48.25 xx/yy
+3702.6 x