Endress+Hauser magphant, Operating Manual

Page: 10 / 24

Mounting of the adapter piece for steel piping
1. Insert the Magphant into the weld stub and tighten the union nut by hand.
2. Hold the weld stub with a open-ended wrench size 27 mm.
3. Tighten the union nut a further approx.
1
⁄
2
turn with a open-ended wrench size
36 mm.
Caution!
When inserting the Magphant into a weld stub, care must be taken so that the sensor
tip is not damaged.
2.5 Mounting in plastic piping
The Magphant for mounting in plastic piping is delivered as part of a set, consisting
of the Magphant, an adapter piece made of 1.4435 (316L), and a plastic union nut.
Mounting of the adapter piece for plastic piping
1. Place the plastic union nut over the adapter piece.
2. Carefully insert the Magphant into the adapter piece and hand tighten the metal
union nut.
3. Hold the weld stub with a open-ended wrench size 25 mm.
Tighten the union nut a further approx. 1
⁄
2
turn with a open-ended wrench size
36 mm.
Caution!
When inserting the Magphant into a adapter piece, care must be taken so that the
sensor tip is not damaged.
Wrench size 36 mm
Wrench size 27 mm
Weld stub
Union nut
ba
025y
16
Fig. 8:
Mounting of the adapter piece for
steel piping
Wrench size 36 mm
Wrench size 25 mm
Adapter piece
Union nut
ba
025y
20
Plastic union nut
Fig. 9:
Mounting of the adapter piece for
plastic piping
2. Mounting and Installation Magphant
10 Hauser