TMT84
Installation instructions
Hauser
27
"
Caution!
Do not overtighten the mounting screws as this could damage the head transmitter. Maximum
torque = 1 Nm (¾ pound-feet).
3.3.1
Mounting typical of Europe
A0008281-EN
Fig. 3: Head transmitter mounting (three versions)
Item A
Mounting in a terminal head (terminal head as per DIN 43729, flat face)
Procedure:
1.
Open the terminal head cover (8).
2.
Guide the connection wires (4) of the insert (3) through the middle hole in the head transmitter (5).
3.
Fit the mounting springs (6) onto the mounting screws (7).
4.
Guide the mounting screws (7) through the lateral bores of the head transmitter and the insert (3). Then fix both
mounting screws in position with the circlips (2).
5.
Then screw down the head transmitter (5) to the insert (3) in the terminal head.
6.
After wiring (see chapter 4), close the terminal head cover (8) back on tight.
