Basic safety instructions
Micropilot FMR53, FMR54 FOUNDATION Fieldbus
4
Hauser
1.
,
2.
,
3.
Series of steps
Result of a step
Visual inspection
1, 2, 3, ...
Item numbers
A, B, C, ...
Views
3
Basic safety instructions
3.1
Requirements for the personnel
Personnel must meet the following requirements to perform their tasks:
‣
Trained, qualified specialists must have a relevant qualification for this specific function
and task.
‣
Personnel must be authorized by the plant owner/operator.
‣
They must be familiar with national regulations.
‣
Before starting work, personnel must read and understand the instructions in the manual
and supplementary documentation as well as the certificates (depending on the
application).
‣
They must follow instructions and comply with general policies.
3.2
Intended use
Application and media
The measuring device described in these Operating Instructions is intended for continuous,
non-contact level measurement in liquids, pastes and sludges. Due to its operating frequency
of approx. 6 GHz, a maximum radiated pulsed power of 12.03 mW and an average power
output of 0.024 mW, operation is completely harmless to humans or animals.
If the limit values specified in the "Technical data" and the conditions listed in the instructions
and additional documentation are observed, the measuring device may be used only for the
following measurements:
‣
Measured process variables: level, distance, signal strength
‣
Calculated process variables: volume or mass in vessels of any shape; flow rate through
measuring weirs or channels (calculated based on the level using the linearization
functionality)
To ensure that the measuring device remains in proper condition for the operation time:
‣
Use the measuring device only for media to which the process-wetted materials are
sufficiently resistant.
‣
Observe the limit values in the "Technical data".
