Field Xpert
6 Operating Device Xpert
Hauser
61
4 If supported, an individual block can also be put out of service in the parameter list
–
Open the parameter group Process (name may differ according to device) or Parameters
–
In the parameter list, open the
Block Mode=>Target
parameter
–
Set the value to
OOS
–
Tap on the yellow arrow and if necessary confirm with
Yes
to execute the change
5 Put the blocks back into operation as in Steps 1 to 4 above, but select the option
Auto
6.2.6
Enable function block viewing
Normally Device Xpert is not used to configure function blocks: this task is done in the engineering
software for the DCS in use. For this reason, the default setting for Device Xpert is to hide the
corresponding information. If you wish to see the function blocks in the block list, they can be
enabled as follows.
1 From the Device Xpert start page select
View => Configuration
