endolite linx, User Manual

Page: 8 / 76

938354S/1-0618
6
Battery
Charger
LED
Battery
Charger
Fully charge the battery before first use.
We recommend that the Linx limb should be fully
charged every night. It should take 8 hours to charge
fully. We also recommend battery charging whenever
convenient.
Step by Step Guide:
1. Lay the limb on a flat surface.
2. Switch the Battery On/Off switch to ON.
3. Connect the charger plug to the charging socket on
the posterior part of the knee module.
4. Check the Battery Charger LED is flashing green to
confirm the battery is charging.
5. Refer to table below to ensure limb is charging.
6. Disconnect from the charger when charged
sufficiently.
7. Wait for 30 seconds while observing the Linx Limb
LED changing color as indicated:
Battery Charging
(continued)
Battery Charger LED Charging state
Yellow Standby
Green > fast flashing Fast charging
Green > slow flashing Close to full charge
Green Maintain (trickle charge)
Yellow > fast flashing Error (Ensure Battery Switch is ON)
NOTE:
If the charger LED is yellow and the limb is
making a clicking noise check that the Battery
switch is in the ON position.
Linx
limb
LED
Linx Limb
LED
Red Blue Red Green Off
Linx limb
8.
1.0N+
After a successful reset sequence, 2 short
beeps will be heard.
9. If reset sequence is unsuccessful or the LED remains
Red, switch the battery off then on and repeat from
step 7.
1.0N+
You can enable or
disable the audible reset
confirmation by pressing
and holding the [ + ] and [ - ]
buttons simultaneously for
2 seconds. The change will
be confirmed by 2 short
beeps.