Contact 1.800.762.1142 for assistance.
Do not return to place of purchase.
®
Owner’s manual: model 235000 outdoor patio heater
11
Step 8 – Connect Gas Line to Engine
Attach gas line to control valve:
Pull collar of gas line back . (small arrow)
Insert gas line over control valve . (large arrow)
Release collar and it should lock in place . (Tip – push gas line up from bottom of post to
make a good seating before releasing the collar .)
Gently tug on line to test for proper connection . If gas line moves you are not properly
connected . Do not proceed until you have a proper connection .
Fully tighten the (4) screws from step 6 .
Step 9 – Attach Top Dome to Emitter
Gently lay heater on its side using one styrofoam insert to prop
up top half .
Align holes in dome with threaded studs in emitter brackets .
Secure dome to emitter using 3 cap nuts (H) . Tighten using 13 mm wrench .
Stand heater upright .
NOTE:
The white ceramic cone in the top of the engine is
an important piece . DO NOT REMOVE .
Step 10 – Secure Gas Line
Make sure angled side of gas clip pokes up through large hole in platform .
Tighten screw until gas line is held securely in place .
Stand heater upright .
Section View
Gas Line
Clip
Gas Line
Bottom View
