22
MEASUREMENT PROCEDURES
⑤
The right screen is shown when pressing
(ENTER) Key
at the Battery System Test
Result screen. Select
YES
and press
(ENTER) Key
to go back to Step
③
Battery
Voltage Selection screen on Page 14.
Select
NO
and press
(ENTER) Key
to
go back to Step
④
Result of Battery
System Test screen on Page 21.
※
The following results are displayed.
・
Start performance test result
・
Starting voltage (cranking battery voltage)
・
Start performance (the ability that battery starts an engine)
・
Charging system test result
・
Charging voltage (battery voltage at the time of charging)
・
Ripple voltage (ripple voltage of diode)
・
Comment
※
Operating Instructions are displayed in the last page of the test result.
Press
(ENTER) Key
to move on to the Exit screen.
Press
(MENU) Key
to move on to the Menu screen (Print / Save Data / Delete Save
Data). (refer to Page 23)
MENU
※
The measurable battery voltage of this product is DC8V or higher, but the testing
carries out normally even if the battery voltage drops lower than DC8V during Start
Performance Test.
※
Start Performance Test is not applicable to check the starter condition.
※
The message "Start Performance 0%" means that the tested battery almost has no
power to start an engine. It does not mean the starting probability.
※
When re-testing, turn on the electric components as much as possible. (fog lamp, rear
defroster, room lamp, etc.)
Do you want to exit?
YES
NO
Press
(BACK) Key
to go back to the
Result
of Battery System Test screen
(Step
④
on
Page 21).
Do not forget to turn off the electric components after finishing
the re-test.
CAUTION
