Pressing the
and
buttons together will silently arm and disarm the system.
Adding or replacing Transmitters.
To replace lost or stolen transmitters or to add additional transmitters into the system.
Please have all desired transmitters ready and follow the steps below.
Note: Up to 4 transmitters can be programmed to operate the system. To erase any
previously stored transmitter codes, be sure to program all 4 transmitter memory
locations.
To program the transmitter(s):
1. Turn on the ignition key On, Off, On, Off, and back On.
· The siren will chirp 3 times.
2. Press and hold the Override switch for 5 seconds.
The siren will chirp 5 times.
The LED will illuminate.
3. Press Button 1 on the first transmitter.
The siren will chirp once.
4. Repeat steps 3 and 4 for each transmitter (up to 4).
5. Turn off the ignition key.
Tamper Alert
If the system was triggered while away, the LED will flash to indicate which zone
system after disarming and turning on the ignition. The LED indication will repeat
LED Flashes:
1 flash ----- optional sensor
2 flashes ------ shock sensor
3 flashes ------ not used
4 flashes ------ door
5 flashes ------ trunk
10 flashes ------ main power interrupt or system was reset
example: flash-flash-pause-flash-flash pause = shock sensor
Remote Arming
The system monitors 3 independent areas (zones) while armed: doors, hood/trunk,
and shock sensor input.
To Arm the System:
1. Turn off the ignition.
2. Press Button 1.
The siren will chirp once.*
