Shock Sensor: Adjustment
The two stage shock sensor is to be installed under the driver’s side dash as close to
the middle of the vehicle as possible. It has two adjustments.
One for the first stage known as warn away. This will trigger a few horn and siren
chirps if the vehicle has sensed a small impact.
The main or second stage will trigger on a heavier impact and put the system in full
alarm mode.
Both of these zones are independently adjustable with a small standard screwdriver
at the shock sensor.
Clockwise = MORE SENSITIVE Counter Clockwise = LESS SENSITIVE.
When the ignition of the vehicle is in the OFF position, The
LED can be used to adjust the sensor. The LED of the
system will flash slightly every time the sensor detects impact.
Please note that the interior LED will be ON solid when the
Ignition is OFF and any trigger is present. This will
happen if the doors are open or if the shock sensor is
showing trigger.
SYSTEM PROGRAMMING:
Entering System Programming
To enter System Programming;
1. Turn on ignition.
2. Within 5 seconds, press the valet switch 5 times.
The siren will provide one rapid chirp, indicating that you have entered
Programming. The horn will not sound entering programming mode but
the LED will light solid after 2 seconds indicating you have entered
programming mode.
3. Press the valet switch the number of times equal to the System Parameter
you want to change.
The siren will chirp each time the valet switch is pressed.
4. Within 5 seconds, press the transmitter button corresponding to the
desired operating mode for that System Parameter.
The siren will chirp to indicate the setting.
I chirp ---- Button 1
2 chirps ----
Button 2
3 chirps ----- Button 3
5. When you are finished, turn off the ignition to save the changes.
Only program one feature at a time and start again for other options.
