3. Install the Adapter
1. Turn off the computer.
2. Remove the computer’s cover, in accordance to its
manual.
3. Insert the contact edge of the adapter card into the
connector of any available PCI Bus master expansion
slot. Press the card firmly into the connector to PCI slot.
Please make sure that the card’s contacts are fully
seated in the PCI slot.
4. Install the bracket screw that secures the card to the
Computer chassis.
5. Replace the computer’s cover.
6. Connect the CAT3 or CAT5 UTP cable to the RJ-45
network connector.
7. Remove driver diskette from the PC diskette drive.
8. Turn on the computer.
9. If the BIOS section of your computer’s boot program is
Plug and Play compliant, then at power up the BIOS will
configure any newly installed adapter automatically.
Note:
Due to some Plug-n-Play BIOS programs' problem, it
happens occasionally that a newly installed adapter is
assigned an interrupt number that is already used by another
device adapter. In such a case, the conflict of interrupt
number will cause faults in the behavior of both devices.
Then it is necessary to run the CMOS Setup utility, and
manually assign a non-conflict Interrupt Number.
4. Driver Diskette
The divers diskette contains all the popular operating system
drivers.
Windows 98SE/ME/NT4.0/2000/XP
Linux
3
Netware 4/5/6.X
