Encore 52K23A Prowler Mid-Cut Operator'S Manual Download Page 15

ENCORE WARRANTY

For Prowler and Z Series Mowers
(

excluding the Z 34

)

This warranty extends to the original retail purchaser only and commences on the date of original
retail purchase. Any part of the Encore commercial mower manufactured by Encore Mfg. Co.,
Inc. and found in reasonable judgment of Encore Mfg. Co., Inc. to be defective in material or
workmanship will be repaired or replaced by an Authorized Encore Dealer without charge for
parts and labor. The Encore mower including any defective part must be returned to an Autho-
rized Encore Service Dealer within the warranty period. The expense of delivering the mower to
the dealer for warranty work and the expense of returning it back to the owner after repair or
replacement will be paid by the owner. This warranty is limited to two years for frame, deck,
hydrostatic drive system (excluding hoses), cutter housings, gearbox, and driveshaft.  The war-
ranty will be 

2 years from the date of purchase

 against defects in workmanship and materials

(90 days for rental use) for any Encore rider that is used for homeowner, commercial or any other
income producing purpose.  Belts, batteries, and tires are warranted for 90 days against defects
in materials and workmanship.
Cutter housings, electrical components, hydraulic components and electric-clutch must be re-
turned before warranty will be paid.
The engine is covered by its respective manufacturer please refer to the manufacture’s warranty
statement that is included in the literature packet. Engine warranties should be referred to the
nearest authorized service outlet of the engine manufacturer.
The responsibility of Encore Mfg. Co., Inc. in respect to claim is limited to making the required
repairs or replacements, and no claim of breach of warranty shall be cause for cancellation or
recession of the contract of sale of any Encore mower.
Proof of purchase is required by both Encore and the servicing Dealer, before any warranty will
be paid, and warranty work must be preformed by an Authorized Encore service dealer.
This warranty does not cover any Encore mower that has been altered or modified so as to
adversely affect the intended use of the product, it operation, performance, or durability. This
warranty also does not cover any mower that has been subject to misuse, neglect, negligence,
accident or that has been operated in any way contrary to the operating instructions as specified
in the Operators Manual.
Encore Mfg. Co., Inc. reserves the right to change or improve the design of any mower without
assuming any obligation to modify any mower previously manufactured.
Encore Mfg. Co., Inc. obligation under warranty is strictly and excessively limited to repair or
replacement of defective parts. Encore Mfg. Co., Inc. does not assume or authorize anyone to
assume for them any other obligation.

ENCORE MFG. CO., INC. CANNOT BE RESPONSIBLE FOR THE WAY YOU OPERATE, OR
THE CONDITIONS IN WHICH YOU OPERATE THE MOWER. USE COMMON SENSE AT ALL
TIMES.

As of  May 1, 2003  this warranty statement supersedes any warranty statement published by
ENCORE MANUFACTURING CO., INC.

Summary of Contents for 52K23A Prowler Mid-Cut

















Reviews: