Doc. No: 01999929
Revision: C
6 of 10
Issue Date: 08/15/21
PART IV
PANEL ASSEMBLY
Prior to proceeding; with hole saw, cut hole in the appropriate panel as required to accommodate the
water supply line.
1. Locate (1) ITEM 5 , (2) ITEM 6’s, (1) ITEM 7, and (1) ITEM 8.
SEE FIGURE 10.
FIGURE 10
2. Place ITEM 5 in ITEM 6 and insert into top center hole of ITEM 12. Place ITEM 7 over ITEM 10 with flat side
towards panel;
SEE FIGURE 10
. Lift ITEM 12 with UV tag side out onto ITEM 7 and attach as follows; with ITEM 7
on ITEM 10, place ITEM 6 over ITEM 5 followed by ITEM 7 such that the flat side of the clamp lies against the
fender washer. Tighten ITEM 8.
SEE FIGURE’S 10 & 11.
Note: Panel can be supported by single top center clamp. Center panel on structure prior to attachment of
additional clamps.
FIGURE 11
Top Left Front Corner
