Enatel DC System Manual
Page
22
of
26
Model: RWxxx
Version: 3.6
6.8
Adjust Temperature Compensation Slope
The rectifier assumes that the battery temperature is 25°C when the Temperature
Compensation Probe is not connected. Disconnect the Temperature Compensation
Probe, and adjust the boost and float charge voltages to that required for 25°C.
Reconnect the Temperature Compensation Probe and cool the metal lug to 0°C (using a
container containing ice and water - do not immerse the probe in the water as it is not
waterproof).
Adjust the Temperature Compensation Slope to set the required charging voltage at this
temperature as determined by the manufacturer’s specification.
6.9
Adjusting the alarm output volt low/high setting
The High Volts and Low Volts Alarm Thresholds can be adjusted to suit the application.
This adjustment requires a variable voltage power supply (that has a maximum voltage
exceeding the over-voltage value to be set).
Connect the variable voltage power supply across the load connections of the rectifier
(check that +ve output of the variable supply is connected to the +ve load connection).
Disconnect the Temperature Compensation Probe. Connect an accurate voltmeter across
the output. Turn the mains on to the rectifier and adjust the variable voltage power
supply up until the alarm activates. Adjust the ‘Alarm Output High’ trimpot to set the
alarm limits. Use the same procedure to adjust the ‘Alarm Output Low ‘ limits. See
Appendix I
E
NATEL
E
NERGY
S
TANDARD
L
IMITED
W
ARRANTY
P
OLICY
Enatel warrants that its products shall be free from defects of material or workmanship
under use consistent with correct installation and commission, normal operation, product
specifications, Enatel’s written instructions, and regional standards compliance, for a
period of one (1) year from the start date. The start date shall be defined as (a) the date
the product is shipped from Enatel’s factory; or (b) in the case of resale by an authorized
Enatel reseller, whichever is the lesser of i) the date on the sales invoice or ii) ninety (90)
days after original shipment by Enatel factory.
The warranty provides for repairing or replacing, at Enatel’s sole discretion, those
products deemed defective by Enatel after inspection of its products returned by the
customer to the factory or other Enatel authorized location within the warranty period.
Replaced product provided by Enatel under the terms of this warranty does not extend
the original warranty, replacement product assumes the warranty of the original product.
Repaired product or component thereof has a warranty period of ninety (90) days or the
remainder of the unexpired term of the original product warranty, whichever is greater.
