Version
Document Title
Release Date
01
WT 2.1
–
Owner’s Manual
2021-03-12
15
Electrical Connection Guide
Attention!
Double-check all the wiring connections
–
before
supplying power to the
device. Failure to adhere to the following instructions can damage the device
and lead to hazardous conditions around the machine!
Never handle the electrical connections with wet hands!
Before mounting the power input cable to the female connector, ensure the ferrite (included with
each WT) is in place around the cable as close as possible to the male connector (Figure 2). The ferrite
has an internal diameter of 13.77 mm (350 Ohm, 150 MHz) and can simply be slid over the cable.
Figure 2
Connect the WT 2.1 to the female electrical port labelled "Power." In the image above, brown is live,
blue is neutral, and yellow/green is the ground. Follow the relevant safety standards and ensure that
local rules and regulations are followed. The minimum cable cross-section diameter for each
connection is 0.5 mm
2
. Ensure to use the male connector in the correct orientation, as shown below.
Figure 3
L
(LIV
E)
N
(N
EU
TR
A
L)
