Version
Document Title
Release Date
01
WT 2.1
–
Owner’s Manual
2021-03-12
14
Following the steps outlined in the water connection instructions
above, connect the 8mm Ø LLDPE pipe to the "H
2
O OUT" port,
located at the top left of the front panel, directly to your
electrolysers. Use an 8mm stem elbow, if needed. From this port,
high-pressure water comes out.
Be sure to connect this port to the "H2O IN" port of the EL.
Water Inlet Connection Guide
Following the steps outlined in the water connection instructions above, connect
the 10mm Ø LLDPE pipe to the "H
2
O IN" port, located at the bottom left of the
front panel.
It is an inlet port. You must connect the source of water you want to store inside
the tank (this source must be deionized water with a conductivity
<20microSiemens/cm).
