Enapter EL 2.1, Owner'S Manual

Page: 5 / 44

Version Document Title Release Date
02 Narrow Body EL2.1 (REV. A) – Owner's Manual 2021-03-22
EL 2.1 - Owner’s Manual - Rev.02 – Mar 2021 4
P
RODUCT
O
VERVIEW
Enapter's patented anion exchange membrane (AEM) electrolyser is a standardised, stackable and
flexible system to produce on-site hydrogen. The modular, easily maintainable design
– paired with
advanced software integration – allows set up in minutes and remote control and management. To
achieve the required hydrogen production capacity, simply stack this on any housing you wish.
Front Panel
The front panel of the EL2.1 includes all physical connections of the device – allowing for easy access
for installers and maintenance personnel only from one direction.
1) H
2
O In – please refer to the section " Water and vent line connection instructions " below
- Push-fit female bulkhead connector (8mm OD pipes)
- Requirements: Water input conductivity <20 µS/cm, input pressure = 0.5 → 4 bar
2) O
2
Vent – please refer to the " Water and vent line connection instructions " below
- Push-fit female bulkhead connector (10mm OD pipes)
- Output: O
2
/H
2
gas mixture and water vapour
3) H
2
Out – please refer to the " Hydrogen Outlet Connection Guide " below
- ¼" double ferrule female compression Swagelok tube fitting 1/4" bulkhead (SS-400-61)
- Output: 500 NL/hr of H
2
, up to 35 bar
4) H
2
Purge – please refer to the " Purge Connection Guide " below
- ¼" double ferrule female compression Swagelok tube fitting 1/4" bulkhead (SS-400-61)
- Output: Up to 20 NL/purge
5) Fill / Drain Port
-
CPC quick connector 10 mm