Perfect for viewers with impaired motor coordination! Our oversized TV remote
control is perfect for viewers with impaired motor coordination. The wireless
remote features a large striking area with 2" push buttons. The buttons are
clearly labeled with words and symbols for Channel, Sound and On/Off
functions. Uses infrared technology. It also will control the latest flat screen TV’s.
Five input jacks allow you to control the remotes with any of our external
Capability switches. (Not Included).
Size: 15¾"L x 10½"W x 3½"H. cannot be
used with TV/VCR or TV/DVD combination units or satellite TV. Requires 2 AA
Batteries.
Operation:
1. Please refer to the manufacturer’s instruction manual included for
programming directions for this remote, with the exception of Step #1:
Installing the Batteries. Please see below:
2. The Remote requires 2 AA batteries (Not included). Use alkaline batteries
only (e.g. Duracell or Energizer brand). Do not use rechargeable batteries
or any other type of batteries because they supply lower voltage and the unit
will not perform properly. Never mix old and new batteries together or
different brands or types together.
3. You will not be placing any batteries directly into the “One For All” remote as
this is permanently affixed to the base. Instead, please locate the battery
compartment recessed in the back of the Remote base. The battery
compartment cover is secured with a small screw. Use a Phillips head
screwdriver to remove this screw and remove the cover. Insert the 2 AA
batteries into the compartment paying careful attention to proper battery
polarity.
4. Replace the compartment cover and re-secure it with the screw. Test the
unit by pressing the ON/OFF button. The red indicator light should blink. If
not, change your batteries.
5. All programming will be done through the remote’s keypad on the back of
this unit. When programming make sure none of the large buttons on the
front become activated or depressed, doing so will prevent programming of
your TV.
Volume Setting:
6.
To have control of your T.V. volume while running a DVD, VCR, PVR or
CBL/SAT, you will need to lock the Volume as described on page 8 in the
“One For All” instructions. Press and hold SET button until the red light on
the remote blinks twice, then release. Enter 9-9-3 and then press T.V. key
once the Red light will blink twice. Now when you press Vol up,
Vol down or
Mute it will be controlled regardless of the device you are controlling.
Switch Use:
7. You can plug up to 5 separate switches to control the same functions as the
large buttons; this is done via the input jacks located on the front side of the
unit.
Troubleshooting:
If you cannot get your Remote to operate you’re TV, or it will not perform
commands properly:
•
Make sure that your batteries are fresh and installed correctly
(according to proper polarity). *
•
If you are using external switches with your remote, make sure they are
plugged in all the way, there should be no gaps. Test your switches on
other switch adapted devices, to rule out your switches as the source of
the problem.
•
Read the” One For All’s” troubleshooting section on page 15 of the
guide for any additional troubleshooting tips.
•
Try
ALL of the codes listed for your device. Many set-up codes may
allow partial functionality; however, only one code will operate your
device correctly.
•
Make sure that you are within 6-10 feet of your device, with the remote
facing the device, while programming. Make sure that you are within 15
feet of your device when using your remote.
•
If the red light on the remote control does not blink when you press a
key, replace the batteries with two (2) new AA alkaline batteries. Be
sure to install paying close attention to proper battery polarity. *.
•
* NOTE: When you replace your batteries, or remove them for any
reason, you must re-install batteries within 10 minuets, or re-
programming your remote will be required. This is why it is important to
write down the codes that work for your devices and keep both these
manuals in a safe place.
Care of Unit:
The Remote can be wiped clean with any household multi-purpose cleaner and
disinfectant. We recommend Simple Green, which is a non toxic biodegradable
all-purpose cleaner.
Do not submerge
the unit, as it will damage the contents and the electrical
components.
Do not use abrasive cleaners,
as they will scratch the surface of the unit.
Rev 11/8/07
Summary of Contents for 1521
Page 3: ......
