AMETEK CTS
BS 200N100
Operating manual
V 1.12
5 / 21
2.
Operating functions
2.1.
Operating elements on the top side
Figure 2.1 : BS 200N100 Top side
1
Switch Trigger mode :Manual or Ext. / Auto
2
Switch operating mode (normal open / closed)
3
LED Switch closed
4
Button MANUAL Trigger
5
Switch TEST ON / OFF
6
Potentiometer Pulse duration 10ms ...>500ms
7
Potentiometer Pulse repetition 1s...>5s
1
Trigger Mode
Trigger release selection of the BS 200N100 switch:
MAN / EXT
: The trigger is released by manual operation with the button MANUAL, or
via an external trigger signal at the BNC plug EXT.
AUTO
:
After switch TEST ON button, the BS 200N100 switch starts to work.
2
Switch Mode
Setting of the switch mode:
-
NO
: (
N
ormally
O
pen)
The switch is normally open and close at each event.
-
NC
: (
N
ormally
C
losed)
The switch is normally closed and opens at each event.
3
LED Switch closed
The LED is lighted during the switch is closed.
4
Manual Trigger
Select “Manual trigger” mode of the switch. (open and closing time depends the time setting)
-
OFF
:
Initial state
–
ON
:
One switch event is released.
5
TEST
On / Off switch for start the electronic switch:
-
OFF
:
Switch out of service (switch status depends on setting NC or NO).
–
ON
:
Switch in operation (open and closing time depends the time setting).
6
Pulse Duration
Potentiometer for adjust the switch duration.
Range: 10ms ... > 500ms ± 5%
7
Pulse Repetition
Potentiometer for adjust the repetition time.
Range: 1s ... > 10s± 5%
