18
1. Check Battery:
NOTE:
Before first and consequent uses, charge battery using the supplied battery charger. To charge: Plug male
end of charger to the socket located on the right side of the LCD screen. Make sure the plug fits snugly into the
socket. PERMANENT DAMAGE MAY OCCUR IF FORCE IS USED TO PLUG THE MALE END OF
THE CHARGER INTO THE SOCKET. A green indicator
When charging is done (usually 3-4 hours on a fully discharged battery), a green steady light will illuminate.
Typical charge may last 2 hours of use depending on frequency and intensity of treatment.
NOTE:
charger plug is plugged into an outlet. Once charged or not in a charging mode, disconnect the plug from the
device. Use of unapproved charger (not issued by EMSI) may cause damage to device and will void any warranty.
CONNECTING THE STIMULATOR
2. Connect electrodes to lead wires:
Insert the lead wire connector into electrodes connector (standard 0.08 inch female connection).
MAKE SURE THAT NO BARE METAL OF THE PINS IS EXPOSED
10.0
| Interferential Treatment Functions Descriptions continued
NOTE:
Always read this instruction manual before use.
PREPARATION FOR USE
Proceed to insert battery pack into the battery compartment. BE SURE TO MATCH THE POSITIVE AND
NEGATIVE ENDS OF THE BATTERY PACK TO THE MARKINGS IN THE BATTERY COMPART-
MENT OF THE UNIT.