![EMS Sky Connect Series Installation Manual Download Page 40](http://html.mh-extra.com/html/ems/sky-connect-series/sky-connect-series_installation-manual_2404674040.webp)
1616-964-12
Date: 7/27/2011
Rev. 2.1
MMU/MMU II Annunciators - The MMUs have their own annunciator that
will illuminate a light for the following reasons;
Incoming Message - To provide a heads up indication to the pilot if the MMU
is installed out of the scan view of the pilot, the “Incoming MSG” light will
blink slowly for five seconds.
Incoming Call - As above the “Incoming Call” light will flash with the ring of
the phone to allow the pilot to know there is an incoming call if the audio
monitor switch is off.
4.4
POST INSTALLATION TESTING
No testing can occur until a valid SIM card is installed in a transceiver, the PIN code
turned off, and the account has been activated with an Iridium service provider.
Systems are generally shipped with a SIM card installed, with the PIN code disabled,
and the service inactive. The customer is responsible for this activation as the
customer receives the bills for the phone use. This process can take some time, and
should be done in advance of the installation/testing.
4.4.1 MMU II CONFIGURATION
Entering Installer Configuration mode is one CCW pushed-in detent of the rotary
knob while pressing the ‘*’ key from either the Ready page, or from the initial MMU
splash display page. The following parameters may be set in Configuration mode:
4.4.1.1
Config Version - Internal use, for informational purposes. This description is
valid for Config Version 2.
4.4.1.2
WiFi Channel - Select the WiFi channel the MMU should use, or “No” to
deselect WiFi. Note: to shutoff WiFi completely, you must select and save a
value of “No” and then power-cycle the MMU. (only appears for MMUs with
WiFi capability)
NOTE: Wi-Fi usage on the aircraft in flight requires the aircraft to have a EMI test
against interference from TPEDs (Transmitting Personal Electronic Devices).
This would be any device carried on to the aircraft that would emit 802.11 Wi-Fi
signals. The MMU II itself transmits approx. 10mw of 802.11 signal. TPEDS
can produce as much as 4 watts of 802.11 signal when searching for a hot spot. IF
you are to use TPEDS, the EMI test must be complied with on your aircraft with
your suit of avionics as installed.
4 - 8
Summary of Contents for Sky Connect Series
