IM 610179-1, Rev 02
08/25/06
Page 12
User Interface Overview
The IPWMM (IP connected wireless modem module) allows the user to monitor the operation of
the repeater and control some of it’s function remotely. The modem connects through a
CDMA200 network and looks and acts like an IP connection. Once the user knows the IP
address of the modem he/she can connect to the repeater using a laptop connected to the
internet.
The IPWMM also can be connected directly to a computer through an Ethernet Crossover Cable
and will then allow local monitoring and control of the repeater. Password protection is used to
control access to the repeater.
The EkoMini will Auto-Setup on Power Up so it is important to ensure the RF input and output
cables are connected before plugging in the unit to a power source. The IPWMM requires up to
3 minutes to load and connect to the network after power up even though the EkoMini typically
sets up in less than 30 seconds.
List of items and information needed to configure the EkoMini. See the Table below for a list of
items needed.
Item Number
EMS Part Number
Description
1.
-na-
EkoMini IPWMM, Site ID or Cascade
Code pre-programmed into the repeater
2.
-na-
A computer running windows and
Ethernet port (RJ45)
3.
-na-
Ethernet crossover cable
4.
EkoMini User’s Guide
5.
-na-
A Site ID or Cascade code for the
repeater.
6.
-na-
The SNMP server IP address. This is
where heartbeats and other SNMP
messages will be sent. The format is
standard IP format, 255.255.255.255
7.
-na-
The desired heartbeat time in minutes.
Summary of Contents for EkoMini M1.9
