EMS Wireless EkoMini M1.9, Operator'S Manual

Page: 11 / 41

IM 610179-1, Rev 02
08/25/06
Page 10
On Off No DC Input Power Applied Green DCPower on, normal function Green
Flashing DC Power on, Set up fault-Band Selection
Alarm Off
No Alarm
Red Flashing 5 Minute Warning
(See list of alarms) Red
Alarm
Uplink RF
Power levels per picture below
Downlink RF Power levels per picture below
No RF Uplink Detected; this is a normal state for the uplink RF path. The normal levels of RF
received and amplified from the subscriber unit may be below the -10 dBm detectable level. A
quick check can be made by getting within a few feet of the Rerad Antenna, while watching the
Uplink RF indicator.
Primary Power
The EkoMini with IP Modem operates on AC input voltages of 100 to 240VAC only.
Donor Antenna
This input/output is connected to an antenna, which is directed at the desired cell site.
Rerad Antenna
This input/output is connected to an antenna, which is mounted in the desired area to be
covered. The antenna should be mounted at a location where adequate coverage is provided
for the area desired while EkoMinimizing the potential of subscriber units normally operating
close enough to overdrive the unit.
Serial Number
Each unit has a unique electronic serial number. This number is displayed on the decal on the
unit and is also displayed with the history log when using the modem interconnect.
Installation:
Note 1: Only qualified technicians should perform Installation and system set up. The user is
cautioned that modification or changes to this device not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
Note 2: Manufacturer's rated output power of this equipment is for single carrier operation. For
situations when multiple carrier signals are present, the rating would have to be reduced by 3.5
dBm, especially where the output signal is re-radiated and can cause interference to the