Empire VFIL18N, Installation Instructions And Owner'S Manual

Page: 31 / 40

26532-2-0410 Page 31
DECORATIVE ACCESSORY INSTALLATION
WARNING: Failure to position the parts in accordance with
the diagrams and instructions below or failure
to use only parts specifically approved for use
with this heater may result in property damage
or personal injury.
NOTE: The Loft series burners may be operated with or
without the Decorative accessory options. Follow the
directions below should you choose to enhance your
Loft burner with any one of the available decorative
options.
DECORATIVE GLASS ACCESSORY PLACEMENT
The Decorative Glass options are available in various colors and
package sizes. Choose the proper size kit for use with your par-
ticular Loft burner.
CAUTION: Use of gloves and eye protection is required while
applying the decorative glass.
INSTALLATION
1. Application of the Decorative Glass should only be per-
formed after the Loft burner has been fully installed, secured
and tested for leaks. If operating the burner with a Remote
Control, make sure all batteries are installed and that the Loft
burner operates with the remote correctly.
2. Before applying the glass to the burner top, attach the black
silicone "U" channel edges (located in the Instruction Enve-
lope) to each side of the Top Cover. See Figure 29. These "U"
channels will help keep the decorative glass from falling over
the outside edges of the Top Cover.
SILICONE
“U” CHANNEL
S
Figure 29
3. To install the Decorative Glass, cut off a corner of the plastic
bag and proceed to apply the glass to the rear shelf on the Loft
burner (area behind the burner). Apply only enough glass to
the Top Cover to cover the black metal surfaces. Do not al-
low the glass to fall around the burner tube. See Figure 30.
Apply the remaining decorative glass to the front sloped sur-
face of the Top Cover. Start by placing the glass along the
front edge of the top cover, then gradually place the glass up
the sloped top until completely covered. Do not allow the
glass to fall around the burner tube. See Figure 31.
CAUTION: Glass must not be placed around the ends of the
Loft burner assembly that would restrict air flow, or cover the
gas valve.
Figure 30
Figure 31
Figure 32