26532-14-0914
Page 22
VFIL SERIES OPERATING INSTRUCTIONS
Thermostats are not approved on vented decorative
appliances.
Label all wires prior to disconnection when servicing con-
trols. Wiring errors can cause improper and dangerous op-
eration. Verify proper operation after servicing.
The VFIL series Loft Burners operate with a GV60 battery-
powered electronic remote ignition and control system.
Prior to operation of the VFIL series Loft Burner, install AA
batteries into the Remote Receiver module, and 9-volt bat-
tery into the hand held remote.
The remote control and receiver should be programmed to-
gether from the factory. All settings for time and temperature
control must be set up by the user as desired.
Installation of the Burner Support Legs
The VFIL series Loft Burners must be elevated with the four
burner support legs as illustrated by figures 10 and 11 on
page 15.
Caution:
The Remote Receiver module must be placed un-
der the right hand side of the burner base prior to operation
of the appliance.
GAS INLET
(3/8 NPT)
MAIN VALVE KNOB
MANUAL
KNOB
INLET PRESSURE TAP
OUTLET PRESSURE TAP
REMOTE RECEIVER
MODULE(PLACE
UNDER BURNER BASE)
NOTE: GAS FLEXLINE WITH SHUTOFF VALVE
(SUPPLIED BY INSTALLER) TO BE ATTACHED
TO GAS INLET ON VALVE.
Figure 17
