27136-0-0110
Page 7
Locating Firebox
Place firebox in framing opening. Use the four (4) framing brackets
provided on the firebox to attach firebox to framing. Different hole
locations can be used for finishing materials with thicknesses of
3/8", 1/2" and 3/4". Attach these materials with screws provided,
two (2) per framing bracket.
See figure 7.
Framing brackets should fit directly against framing material. Use
at least one (1) nail per bracket to secure in place.
Check squareness of the firebox prior to securing to framed opening.
See figure 8.
figure 7
A black hood that is furnished with each firebox (or optional hood)
MUST be installed before the firebox is used. Failure to do so may
create a possible fire hazard. The hood is located inside the firebox.
if brass, stainless steel, or hammered pewter hoods are desired,
they can be purchased as an option. attachment is the same as the
standard black hood.
1. Loosen the two screws (A) holding firebox top to face panel,
then slide the hood flange between the firebox top and face panel
and re-tighten the screws.
2. install one (1) screw at each end of the hood as shown (c).
caution:
The hood must be installed prior to operation of appliance.
See figure 9
ATTACH (4)
FRAMING BRACKETS
TO SIDES OF FIREBOX
PRIOR TO INSTALLING
UNIT TO FRAMED OPENING
A
C
A
C
figure 9
FIREBOX OPENING
CHECK TO SEE
THAT BOX IS SQUARE
PRIOR TO ATTACHING TO
FRAMING
figure 8
FiReBoX inSTaLLaTion inSTRUcTionS (continued)
inSTaLLing HooD
