![background image](http://html1.mh-extra.com/html/empire-comfort-systems/vfp20in20/vfp20in20_installation-instructions-and-owners-manual_2404008021.webp)
26497-1-0310
Page 21
Before you begin: Do not, handle these logs with your bare hands!
Always wear gloves to prevent skin irritation. After handling logs,
wash your hands gently with soap and water.
All Logs
The positioning of the logs is critical to the safe and clean operation
of this heater. Sooting and other problems may result if the logs are
not properly and firmly positioned in the appliance.
Warning:
Failure to position the parts in accordance with
this diagram or failure to use only parts specifically approved
with this appliance may result in property damage or personal
injury.
pROpER INSTALLATION SEqUENCE:
(Figure 21)
1. Place rear (#1) log onto two (2) pins on rear log support.
2. Place left, front (#2) log onto two (2) left, front pins on burner
pan.
3. Place right, front (#3) log onto two (2) right, front pins on
burner pan.
4. Place Y Branch (#4) onto two (2) pins on rear log.
5. Compare the completed log installation with the photo on
page 22. Review previous steps to make any necessary
adjustments.
6. Log placement is completed.
7. Attach log placement plate to cable holding lighting instructions
for future reference.
Attention:
Do not use Figure 21 to order replacement logs. Refer
to Page 34 Parts List and Parts View to order logs.
Rock wool can be added to burners for a glowing ember effect.
Apply loose material (glowing embers) only on locations shown
on Page 22. Replacement of loose material (glowing embers) must
be purchased from Empire Comfort Systems, Inc. Application
of excess loose material (glowing embers) may adversely affect
performance of the heater.
WARNING: All previously applied loose material must be removed
prior to reapplication.
8. Install front frame assembly.
Replacement Loose Material (glowing embers) part
Number: 15999
Note:
A single layer of embers is to be used when applying
Platinum Bright Embers (alone or in combination with
production embers) to the burner.
Log placement
Figure 21
1
2
3
4
VFp28IN LOG pLACEMENT