![background image](http://html1.mh-extra.com/html/empire-comfort-systems/vfll38fp/vfll38fp_installation-instructions-and-owners-manual_2404003011.webp)
32707-8-0714
Page 11
3. Lift the complete burner and valve assembly upward, then turn
it sideways in fireplace opening to gain easy access to the
junction box.
See Figure 13.
You may remove the complete
burner and valve assembly as shown in
Figure 12.
Figure 13
4 The junction box is located on the right side of the fireplace.
Remove the two 5/16” Hex screws that secure the junction box
to the firebox, and remove the junction box.
See Figure 14.
Run romex wire through the right rear corner of the fireplace
and into the firebox area. Secure wiring with the romex connec
-
tor as required and install the duplex receptacle as shown in
Figure 15
. Attach the black wire to the brass screw side of the
receptacle, and the white wire to the opposite side. Secure the
incoming ground wire under the green ground screw provided
on the receptacle.
Figure 14
Figure 15
5. If only installing the LK5 Accent Light kit, then remove the 7/8”
diameter knockout in the back of the junction box, install the
7/8” diameter protective grommet, and connect the wiring with
wire nuts as shown in
Figure 15.
There is a solid junction box cover plate included with the
LK5 kit that should be used on the junction box if a duplex
receptacle is not used.
6. Once the junction box wiring is completed, re-install the junc-
tion box into the lower right corner of the firebox cavity using
the screws removed in step 4 as shown in
Figure 16.
Figure 16
7. Reinstall the burner and valve assembly and reattach the screws
removed in step 2.
See Figure 11.
8. For VFLL(38,48)FP90: Reconnect the wire from the switch on
the heat shield and put the shield back in place.
JUNCTION BOX WIRING INSTALLATION