35008-12-0519
Page 20
FIReplAce FRAMING AND INSTAllATION
FINISHING
1. After gas and electrical hookup is completed, lower and
secure the burner assembly (leave two supports in bottom of
fireplace for future use) with the two screws removed in Step
7 on page 15.
2. Install the glass wind panel (two used on see-through fire-
places).
See Figure 21.
Figure 21
3. Reinstall the pivot bolts and washers removed in step 7 on
page 15 and reinstall the control door and center pivot pin.
4. Unscrew the ignitor button and install the AA battery provided
in the instruction envelope prior to closing the control door.
See
Figure 22.
Figure 22
Framing and Finishing
The fireplace is installed with panels around the opening as a
clean face installation.
See Figure 23.
The top and sides must
use non-combustible panels (provided) where shown going over
the face of the fireplace. Outside of this area, any weatherproof
wallboard may be used.
NON-COMBUSTIBLE
WALL BOARD
(PROVIDED)
FINISHED
WEATHERPROOF
MATERIAL
Figure 23
