![background image](http://html1.mh-extra.com/html/empire-comfort-systems/dvp42fp30n-4/dvp42fp30n-4_installation-instructions-and-owners-manual_2404101053.webp)
31455-10-1115
Page 53
5HPRYHJODVVGRRUDQGSODFHDZD\IURPWKH¿UHSODFH
7XUQRQJDVVKXWRIIYDOYH)ROORZLJQLWLRQSURFHGXUH
3. If burner does not light after spark sequence has ended, use
DQLQVXODWHGMXPSHUZLUHEHWZHHQWHUPLQDOORFDWLRQVDQG
13 for fast reset function.
,QWHUUXSW SRZHU IRU VHFRQGV7KH JUHHQ LQGLFDWRU OLJKW ZLOO
blink 4 times repetitively. Then retry for ignition.
$OORZWLPHIRUDQ\UDZJDVWRGLVVLSDWHDQGUHSHDWVWHSVDQG
4 until ignition is achieved.
6. Turn burner off and install glass door frame assembly.
7HVWLJQLWLRQRIEXUQHUZLWKJODVVGRRULQSODFH
NOTE: UNIT MUST BE PROPERLY GROUNDED FOR ELECTRONIC IGNITION TO FUNCTION.
2QLQLWLDOLQVWDOODWLRQRUDIWHUH[WHQGHGSHULRGVZKHUHWKH¿UHSODFHKDVQRWEHHQXVHGJDVOLQHVPD\UHTXLUHSXUJLQJ
7KHLQVWDOOHURUTXDOL¿HGVHUYLFHSHUVRQPD\XVHWKHIROORZLQJSXUJHSURFHGXUHVWRSUHYHQWWKHGHOD\VWKDWZRXOGEHFDXVHGE\ZDLWLQJ
IRUWKHORFNRXWSHULRGVEHWZHHQWULHVIRULJQLWLRQ
INSULATED
JUMPER WIRE
PURGE PROCEDURE
:LWKSURSHULQVWDOODWLRQDQGPDLQWHQDQFH\RXUQHZ'LUHFW9HQW*DV)LUHSODFHZLOOSURYLGH\HDUVRIWURXEOHIUHHVHUYLFH,I\RXGR
H[SHULHQFHDSUREOHPUHIHUWRWKHWURXEOHVKRRWLQJJXLGHEHORZ7KLVJXLGHZLOODVVLVWDTXDOL¿HGVHUYLFHSHUVRQLQWKHGLDJQRVLVRI
problems and the corrective action to be taken.
SYMPTOM
CHECK
ACTION
1RVSDUNZKHQV\VWHPLVWXUQHGWR³21´DQG
reset cycle* has been completed
&KHFNIRU9EHWZHHQEODFN³KRW´OLQHDW
FRQWUROPRGXOHDQG³ZKLWH´UHWXUQDWPRGXOH
If 120V not present, check fuse or circuit
EUHDNHURUUHSDLUZLULQJOHDGLQJWR¿UHSODFH
0DLQEXUQHUZLOOOLJKWEXWLJQLWHUFRQWLQXHV
to spark for several seconds and then
ORFNVRXWPRGXOHZLOOVKRZWZREOLQNVRQ
indicator light).
'LVFRQQHFWSRZHUWR¿UHSODFHMXQFWLRQER[
DQG FKHFN WKDW WKH +RW%ODFN ZLUH LV
FRQQHFWHGWRWKHJROGUHFHSWDFOHVFUHZ
VLGHDQGWKDWWKH1HXWUDO:KLWHZLUH
LVFRQQHFWHGWRWKHVLOYHUVFUHZVLGH7KH
green ground must also be secured for
proper operation.
3ULRUWRUHZLULQJWKH¿UHSODFHMXQFWLRQER[
check operation of the control system by
running a grounded extension cord from
DQRWKHUVWDQGDUGZDOOUHFHSWDFOHRXWOHWWR
WKH¿UHSODFHFRQWUROV\VWHP)ROORZSXUJH
reset procedure above in order to clear the
light codes.
Spark for six seconds at ignitor, but no
ignition of burner.
a. Check that gas is turned on and system
purged
Turn gas on and/or purge system
b. Check that tips of ignitor are directly
above ports on main burner. Spark is
EHWZHHQ HOHFWURGHV DQG QRW IURP RQH
electrode to burner.
Position electrodes so tips are directly
above burner port ports and about ¼" to
3/8" above burner.
c. Check for 120V at each coil on the gas
valve and listen for click, indicating gas
valve is opening.
If 120V present, but gas valve does not click,
replace gas valve.
Spark for six seconds, main burner lights,
EXWJRHVRXWZKHQVSDUNVWRSV
&KHFN IRU FOHDQ JURXQG SDWK EHWZHHQ
HOHFWURGH EUDFNHW DQG ¿UHSODFH FKDVVLV
&KHFNZLULQJWRZLULQJGLDJUDPODEHO&KHFN
for broken electrode on high-tension lead
attachment to module.
&OHDQSRVLWLRQDFFRUGLQJWRZLULQJGLDJUDP
and repair defective electric connections.
If all electrical connections are clean and
correct, replace module.
Main burner lights normally and then goes
out.
a. Check thermostat if applicable.
Turn thermostat up to call for heat or replace
b. Check high-tension lead and connector
for shorts.
Replace spark electrode assembly
c. Refer to installation instructions
troubleshooting guide for issues such
as venting.
Repair as required.
INITIAL START UP GAS LINE PURGE
DIRECT IGNITION TROUBLESHOOTING
Summary of Contents for DVP42FP30N-4
