![background image](http://html1.mh-extra.com/html/empire-comfort-systems/dvp42fp30n-4/dvp42fp30n-4_installation-instructions-and-owners-manual_2404101032.webp)
31455-10-1115
Page 32
VERTICAL TERMINATION
Locate and mark the center point of the venting pipe. Using a nail
on the underside of the roof and drive this nail through this center
point. Make the outline of the roof hole around this center point.
NOTE:
Size of the roof hole dimensions depend on the pitch of
the roof. There must be a 1 inch clearance (25mm) to the
vertical pipe sections. This clearance is to all combustible
material.
Cover the opening of the vent pipe and cut and frame the roof hole.
Use framing lumber the same size as the roof rafters and install the
IUDPHVHFXUHO\)ODVKLQJDQFKRUHGWRIUDPHPXVWZLWKVWDQGKLJK
ZLQGV7KHVWRUPFROODULVSODFHGRYHUWKLVMRLQWWRPDNHDZDWHUWLJKW
seal. Non-hardening sealant should be used to completely seal this
ÀDVKLQJLQVWDOODWLRQ
Determining Minimum Vent Height Above the Roof.
WARNING: Major U.S. building codes specify minimum
chimney and/or vent height above the roof top. These mini-
mum heights are necessary in the interest of safety. These
VSHFL¿FDWLRQVDUHVXPPDUL]HGLQ)LJXUH
ROOF PITCH
H (Min.)
Flat to 6/12
12" (305 mm)
6/12 to 7/12
15" (381 mm)
Over 7/12 to 8/12
18" (457 mm)
Over 8/12 to 16/12
24" (610 mm)
Over 16/12 to 21/12
36" (914 mm)
Figure 54
Note that for steep roof pitches, the vent height must be increased.
,QKLJKZLQGFRQGLWLRQVQHDUE\WUHHVDGMRLQLQJURRIOLQHVVWHHS
pitched roofs, and other similar factors can result in poor draft, or
GRZQGUDIWLQJ,QWKHVHFDVHVLQFUHDVLQJWKHYHQWKHLJKWPD\VROYH
this problem.
:KHQWHUPLQDWLQJWKHYHQWFDSQHDUDQH[WHULRUZDOORURYHUKDQJ
PDLQWDLQPLQLPXPFOHDUDQFHVDVVKRZQLQ
Figure 55
.
Figure 55
General Maintenance
Conduct an inspection of the venting system semi-annually.
5HFRPPHQGHGDUHDVWRLQVSHFWDUHDVIROORZV
&KHFN DUHDV RI WKH YHQWLQJ V\VWHP ZKLFK DUH H[SRVHG WR
WKH HOHPHQWV IRU FRUURVLRQ 7KHVH ZLOO DSSHDU DV UXVW VSRWV
or streaks and, in extreme cases, holes. These components
should immediately be replaced.
5HPRYHWKHFDSDQGVKLQHDÀDVKOLJKWGRZQWKHYHQW5HPRYH
any bird nests or other foreign material.
&KHFNIRUHYLGHQFHRIH[FHVVLYHFRQGHQVDWHVXFKDVZDWHU
droplets forming in the inner liner and subsequently dripping
RXWDWMRLQWV&RQGHQVDWHFDQFDXVHFRUURVLRQRIFDSVSLSH
DQG¿WWLQJV,WPD\EHFDXVHGE\KDYLQJH[FHVVLYHODWHUDOUXQV
WRR PDQ\ HOERZV DQG H[WHULRU SRUWLRQV RI WKH V\VWHP EHLQJ
H[SRVHGWRFROGZHDWKHU
,QVSHFWMRLQWVWRYHULI\WKDWQRSLSHVHFWLRQVRU¿WWLQJVKDYHEHHQ
disturbed and, consequently, loosened. Also, check mechanical
VXSSRUWVVXFKDVZDOOVWUDSVRUSOXPEHUV¶WDSHIRUULJLGLW\
9HQWLQJWHUPLQDOVKDOOQRWEHUHFHVVHGLQWRDZDOORUVLGLQJ
A removable panel or other means must be provided in the enclosure
IRUYLVXDOLQVSHFWLRQRIWKHÀXHFRQQHFWLRQ
NOTE: This also pertains to vertical vent systems installed on the
outside of the building.
Slide the vertical vent cap over the ends of the vent pipe and secure.
See Figure 56.
Summary of Contents for DVP42FP30N-4
